Schematic Capture : Draw
Drawing a 3 Point Arc
With 3 Point Arc, an arc is created by specifying the start point, end point, and configuration point.
The following will explain each operation for drawing a 3 Point Arc.
Selecting the 3 Point Arc Menu
Drawing a 3 Point Arc
Pushback a 3 Point Arc
Editing the Line Width
Editing Properties (Color, Line Style, etc.)
Canceling a 3 Point Arc
Exiting 3 Point Arc Mode
Selecting the 3 Point Arc Menu
[Draw] => Select [3 Point Arc].
There are several other ways to perform this. Refer to About Executing Menus.
Drawing a 3 Point Arc
After selecting the 3 Point Arc Menu,
STEP 1: Click the third point
STEP 2: Click the second point
STEP 3: Click the third point
| Drawing a 3 Point Arc |
| The following is the operation for a 3 Point Arc. |
|
|
|
 |
|
 |
|
 |
Pushback a 3 Point Arc
When creating a 3 Point Arc, you can pushback the corner to the previous status.
| Before Pushback | After Pushback |
|
|
|
The following is the operation for executing pushback.
Right click, Select => [Pushback].
* Press "Back" on the keyboard.
When not creating a 3 Point Arc, it exits Create 3 Point Arc.
Editing the Line Width
When creating a 3 Point Arc, you can edit the line width.
| Line Width 0.2 mm | Line Width 1mm |
|
|
|
The following is the operation for editing the line width.
STEP 1: Right click, Select => [Edit Line Width] => The "Line Width Settings" window will open.
* This can also be done by pressing "w" on the keyboard.
STEP 2: Input a Line Width, and then click "OK"
It is applied to the whole 3 Point Arc before it is determined.
Editing Properties (Color, Line Style, etc.)
It is possible to edit the Line Width, Arc Style, Line Style, Fill Style, Line Color, Fill Color, Fill Style, etc.
The following is the operation for editing.
STEP 1: Edit values in the Property Window
It is applied to the whole 3 Point Arc before it is determined.
Canceling a 3 Point Arc
When creating a 3 Point Arc, it is possible to return to the status before drawing by canceling the 3 Point Arc being created.
| Before Canceling | After Canceling |
|
|
|
The following is the operation for executing pushback.
Right click, Select => [Cancel].
* Press "Escape" on the keyboard
Exiting 3 Point Arc Mode
The following is the operation for exiting 3 Point Arc mode.
When not creating a 3 Point Arc,
Right click, Select => [Cancel].
* Press "Escape" on the keyboard