This page explains the process of creating a simulation-ready component which is used for LTspice simulations. In order to run a simulation in LTspice, it is necessary to specify the device type and configure the SPICE Pin Order after creating a component.

For how to create a component, see the Creating Components page.

STEP1: Opening a Component Edit Sheet
STEP2: Specifying the Device Type
STEP3: Configuring the SPICE Pin Order

---

Steps for Creating a Simulation-ready Component

A simulation-ready component can be created by completing the following steps:

STEP1: Opening a Component Edit Sheet The first step is to open the component edit sheet.

↓

STEP2: Specifying the Device Type Once you open the component edit sheet, the next step is to specify the device type. It is necessary in order for LTspice to recognize the component kind.

↓

STEP3: Configuring the SPICE Pin Order The final step is to configure the SPICE Pin Order which is necessary when linking with LTspice.

 

For details on each device type, see the Device Type page.

For details on the SPICE Pin Order, see the SPICE Pin Order page.

The sample SPICE libraries are downloadable from here.