Routing can be performed while pressing the route and plane based on the DRC Clearance Settings. (Stop at First Obstacle)
While routing, obstacles can be bypassed automatically, so it is possible to execute routing without clicking just like handwriting. (Normal Routing)

In [Routing] Mode, routing can be done by pressing Route and Plane without clicking.

---

Stop at First Obstacle Mode Settings

The following will explain how to execute Stop at First Obstacle when routing.

(1) [Settings] => [Environment Settings]. Configure "Route" settings. It is possible to use Stop at First Obstacle by placing a check for "Enable the function to stop at first obstacle". By placing a check for "Bypass the obstacles while Routing", normal routing is possible.

You can also confirm the Enabled/Invalid status of Stop at First Obstacle from the button at the bottom of the screen. [PRESS] You can confirm whether Stop at First Obstacle is Enabled/Invalid.

Options

Stop at First Obstacle/Normal Routing operation can be toggled using the following options.

Item	Content
Enable the function to stop at first obstacle	Routing can be performed while pressing the route and plane based on the DRC Clearance Settings.
Bypass the obstacles while Routing	While routing, obstacles can be bypassed automatically.
Keep on Guide	Routing is performed on the nearest Guide in consideration of the DRC Clearance. When this is not checked, routing is performed at a position where DRC Clearance is maintained. (It is not kept on the Guide.)