PCB Layout CAD : DRC/MRC Settings
Solder Resist/Paste
Verify whether Solder Resist or Paste exists on a pad.
Components excluded from the check can be specified using the Reference Prefix (R, C, etc.) or the Reference (U1, C1, etc.).
For more details about opening the DRC/MRC Settings screen, refer to About DRC/MRC Settings.
Check the Existence of Solder Resist
| Item | Content |
|
Select Excluding Component |
Specifies components excluded as check targets for whether Solder Resist is included in a pad using the Reference Prefix (R, C, etc.) or the Reference (U1, C1, etc.). |
|
Via |
When this is checked, it confirms whether Solder Resist exists for the Via. |
|
Pad |
When this is checked, it confirms whether Solder Resist exists for the Pad. |
Check the Existence of Paste
| Item | Content |
|
Check the Existence of Paste |
When this is checked, it confirms whether Paste exists in the SMD Pad. |
|
Select Excluding Component |
Specifies components excluded as check targets for whether Paste exists in the SMD Pad using the Reference Prefix (R, C, etc.) or the Reference (U1, C1, etc.). |
You cannot use both Reference Prefix (R, C, etc.) and Reference (U1, C1, etc.).
| Specifying Adding to Excluded Components |
| The following will explain how to add an excluded component specification. |
|
 |
|
 
|
|
 |
| Specifying Deletion from Excluded Components |
| The following will explain how to delete an excluded component specification. |
|
 |